Remote Control Cars - Handy Do-it-yourself Tips for RC Cars

If you're not from an engineering background butcheck on your tx, rx, glow starts before going
pursue driving remote control cars as a hobby, it'sout with your car also helps. This is a must when
always a good idea to learn as much as possibleyour batteries or lights etc have been in use for a
about remote control cars. We all want some kindwhile.
of help on how to keep unwanted particles fromIf you want an alternative way out to shut down
coming into the car. A quick and simple solution tothe engine in comparison to du-bro exhaust plug
this problem would to secure your air filter.you can use a pencil to plug the exhaust to shut
Alternatively, you could buy du-bro body clipdown the engine fast. Everyone uses the cable tie
retainers and make sure that they remain clippedtrick to fasten the bec plug together so they do
at all times and do not get loose.not get disconnected accidentally. But this does
Sometimes your car may not work properly. Likenot seem practical because every time you have
if you turn on your car and you find that it keepsto cut the tie and use a new one to recharge the
steering to one side. This may happen even if youcells. To overcome this problem, a simple solution
keep the wheels straight. A good remedy in thisis to replace the cable ties with the twist tie that
case would be to check if your car has aholds your rx antenna. They are reusable and do
"steering trim" knob, wheel or button option. Ifthe job perfectly.
there is none then may be adjusting steeringDrilling your tires on the outside edge in the
servo armature length should do the trick.middle, instead of the rim, keeps the dust and
A lot of dirt gets accumulated under the chassisother crap out of your tires. They'll stay in
and it affects the screw heads. To clean thebalance a lot longer as crud gets thrown out as
screw heads under the chassis, spray denaturedyou drive. If you drill the rims, then every bit o
alcohol on screw heads and then pick the dirt withcrap will stay in your wheel.
the help of paper clip. It is recommended to useTo make your own chassis, blank circuit board or
denatured alcohol as it seems to work betteran aluminum plate does a great job. Use vise grips
than the simple green or motor cleaner.to clamp the original chassis to the blank material
Compressed air also works better for cleaningand drill all your holes by drilling straight through
NTC3 after a good day bashing. But an old sockthe existing holes on the original chassis. You'll get
always does the trick to clean your car sparklingeverything to mount up nice that way! If you
and shining. The soft wool or cotton wipes off thebother that the circuit board might be too light. No
dirt like magic. But one has to be sure not leavefret! It is more or less like a fiber glass board and
any lose socks thread going into the car. A smallwork well as top plate on bigger cars too.
painter brush always cleans unreachable areas andTo goose the runtime of remote control car the
cleans them gently. To wipe of sticky mud undersimple trick is to charge them multiple times. If
the chassis or on the body of the car using ayou put your remote control car on charging and
toothbrush to brush it off also helps. But maketake off the plug two- three times then it might
sure not to scratch you car paint with a too hardgive you a good run time because the battery
brush bristles.gets charged all over again. But doing it umpteen
Keeping spare starter batteries and giving a raintimes might prove lethal to battery life.